HOW TO CHANGE ROAD SPEED PARAMETERS WITH CUMMINS INLINE 7 SOFTWARE 8.3 CUMMINS

Cummins inline 7 with  INSITE 8.3.0120 Pro software can performs engine diagnostics and displays electronic engine information..For Many buses owner are not good at how to adjust the speed as required. OBD2repair.com share you detail steps about how to change Road Speed Parameters with Cummins inline 7 Truck Software 8.3 Cummins.

NOTE: This Carolina Thomas Bus Buzz assumes you have a service department laptop with the Cummins Insite Software (official or cheap crack version confirmed to work no issues).

For Latest Cummins Inline 7 Cummins insite 8.3.0120  ，pls check

Cummins INLINE 7 Data Link Adapter Cummins Truck Scanner with Insite 8.3 Cummins

Step 1: Connect the laptop to the bus by using the 9-pin diagnostic receptacle inside every C2 located above the driver’s left foot position.

Step 2: Click on on your desktops Cummins INSITE Icon.

Step 3: Turn key in bus to on position. Bus does NOT need to be running.

Step 4: Click on on “Connect to ECM” menu on left and then click on “Connect” in pop up window.

Step 5: Click on on “Features and Parameters”.

Step 6: Scroll down menu to Road Speed Governor and click on on icon beside to expand its options. The menu is in alphabetical order for ease of use.

Step 7: Double click on on MPH number on MAX VEHICLE SPEED.

Step 8: Enter the new MPH speed required and then click on on the number. Note: North Carolina has specific laws for buses in operation. Please adhere to these laws for any bus in-service.

Step 9: Double click on on MPH number on MAX ACCELERATOR SPEED and change to same value as MAXIMUM VEHICLE SPEED.

NOTE: New speed is displayed and old speed is displayed to the right.

Step 10: On tool bar at top of screen, click on on the small computer icon to send info to engine’s ECM.

Step 11: Pop up window will indicate you are to turn ignition key off for 30 seconds. Do this and then click on OK.

Step 12: NEW pop up window will tell you when to turn ignition key back on. When instructed, turn key on and click on OK.

Step 13: Pop up window will indicate when all parameters were successfully written. Click on OK.

Step 14: Click on Icon on left to disconnect from ECM. When this is complete it is safe to remove laptop connections with bus.

OBD2repair.com Focus On OBD Tool Since 2008

More detail about Cummins inline 7 cummins insite 8.3 software ,pls connect
Website:www.obd2repair.com
Skype：obd2repair / eobdscan1
We Chat/ Whatsapp:+86 137 2882 3163
Email: info@obd2repair.com
Facebook: www.facebook.com/obd2repaircom/