Kess V2 update New Genius Flash Point OBD ChipTuning Tool Genius Touch Map Device
You should have:
John Deere L21-L33 cable
New Genius OBD Chiptuning Tool:
( it’s genuine, but maybe you can have a try with china clone New Genius K-Touch OBD Chiptuning Tool)
How-to: New Genius OBD Chiptuning Tool flash a ECU on the table
Step 1
After removing the ECU from the tractor, wait for 2-3 minutes before you start the operation
Step 2
IMPORTANT: ignition must be off
Step 3
Connect the New Genius with F32GN032 diagnostic cable
Step 4
Connect the L21-L33 cable to the ECU (ignition must be off)
Step 5
Connect the power cable from the L21-L33 with a power supply (+12V)
Step 6
Select the correct vehicle and protocol FLASH_363
IMPORTANT: select TOOL to read at first the injector codes. For more info about this, take it from the Flashpoint Application list.
Step 7
After reading the injector codes successfully, start to read the ECU
OBD2repiar.com IMPORTANT INFORMATION ABOUT THE PROCEDURE:
If the New Genius OBD Chiptuning Tool writes ECU, switch off the ignition, switch it off and wait until the Ampere cool down ca. 0.35A, before you click on OK on the New Genius! (cool down time ca. 10 sec)
Ignition OFF ca. 0.34-0.35 Ampere
Ignition ON ca. 1.10-1.20 Ampere
Reading ca. 50 sec.
Writing ca. 1min 50sec.
OBD2repair.com VERY IMPORTANT NOTE:
Usually, New Genius OBD Chiptuning clone (also named Ktouch) can work as the original.
But if you decide to have a clone, you’d better read the post
“Difference Between New Genius original & New Genius K-touch China Clone”
http://obd2repair01.hatenablog.com/entry/2017/09/04/171041
More detail about New Genius OBD Chiptuning tool ,pls check:
Website:www.obd2repair.com
Skype：obd2repair / eobdscan1
Whatsapp (+86)13728823163
Email: info@obd2repair.com
没有评论:
发表评论